You can easily Google "pillowcase dress" and get a bunch of different variations. I didn't follow a specific pattern, but this site is pretty close to what I did. The only thing I might do differently with the pattern is sew the ribbon straps in place where they come out of the casing. It can be tricky tightening and tying them without pulling the ribbon out. I mean, it is doable, just a little annoying.
I love these dresses because they can be a dress when they are little and a shirt when they are a little bigger. If I use them when Ashlyn is bigger I will just pull out the little seam that I used to hold the ribbon in place and adjust it to where I need it.
And for the flower.
Cut square pieces of fabric or ribbon. I do about 8. These are 2 inch squares, about what I used on Ashlyn's green flower.
Fold a square in half to make a triangle.
Put a dot of hot glue on tip of the triangle, opposite of the fold..
Fold the corners into the glue.
Turn it over. Here (below) I am holding the corner where two sides were folded down to. Put a line of glue left to right.
Fold sides over into glue to the center.
Fold the sides that were just folded to the center, to the center.
Glue closed. Towards the bottom. Make sure the point is glued closed too.
It will look like this.
Cut off the point. Not too much though. If it fans open a little, glue everything closed.
Open the petal. Repeat for all petals. Glue them together like this.
This is what you will have. I usually do about 8 petals, it can be more or less as long as it makes a circle can close.
I put felt on the back, or you can use a piece of the same fabric used to make the flower. You don't have to.
And add a button or whatever on the front. I like the look of a sewn button so I just put thread through the holes and hot glued it on.
Ta da! Just glue it on a clip/pin/headband, whatever.
I hope the steps aren't confusing. I tried to take plenty of pictures. I hope it works out for you.






